3DeeSlide Frequently Asked Questions

The 3DeeSlide is designed to easily snap onto the black iPhone 4/4S from the left hand side of the device. It has been designed to make all buttons and connections available to you when the 3DeeSlide case is put on your iPhone.

To use your 3DeeSlide, gently pull out the lens on the right hand side. Flip the lens so the screen rests on top of the iPhone display and the two tabs fit neatly into the slots on the left hand side of the 3DeeSlide case.

To remove the 3D lens gently pull on the right hand side of the lens. The 3Dee lens should easily slide off. Place lens into the pocket at the back of the 3DeeSlide for later use.

Storing your lens - The lens for your 3DeeSlide is located on the right hand side of your iPhone display. When not in use, the lens neatly tucks away into a pocket at the back of the 3DeeSlide case so it does not get scratched or damaged and is easily accessible when you need to use it.

If you wish, you can wash the 3DeeSlide and 3DeeLens with gentle soap and water and wipe them clean with a soft cloth.

In order to active 3Dee mode to enable glasses-free viewing of 3D content using your 3DeeSlide, you'll have to enter the 3DeeSlide's serial number. Each 3DeeSlide comes with a unique 16 digit serial number. Once entered, this serial number will be tied to your device.

The sweet spot is the viewing position from which you experience the best 3D effect. The viewing distance for the best 3D effect is about 30-40 cm, or 12 to 16 inches. To find the sweet spot, tilt the device a bit left or right, up or down - you will see when the entire image comes into focus with the full 3D effect.